EnvisionTEC® EPIC is a professional injection molding polymer. Recommended for jewelry and industries with high-precision die-casting processes.
A low wax polymer of about 8% provides results similar to EnvisionTEC’s Wax Free PIC100. The polymer provides excellent surface quality, even after casting. The PIC100 is recommended for small products weighing up to 5g, while EPIC can be used in products up to 12g for added flexibility with wax-like additives.
Minimum bearing wall thickness
A wall connected to others on two or more sides.
Minimum incomplete wall thickness
A wall connected to others on less than two sides.
Minimum pipe thickness.
It is an element five times its width. It is connected to the part on both sides.
The minimum thickness of an incomplete pipeIs an element that is five times the length of its width. It is connected to the part on less than two sides.
The minimum thickness of the protruding part.
This is an element that is half the length of its width. The minimum detail is determined by the printer resolution. If part sizes are below the minimum size, the printer may not be able to accurately reproduce them. To keep the details clear, make them larger than the specified minimum. We may refrain from printing models with parts less than the minimum because the final product will not match your design.
Minimal engraved detail.
This is an element that is half the length of its width. The engraved parts come out or sink into the surface.
This is the space between any two parts of the model, walls, or structural elements. To ensure successful printing of the product, the gap between the parts must be greater than the specified minimum.
Minimum drainage holes..
Evacuation holes allow unused material to be removed inside hollow products. It doesn’t need to be taken into account, our technician will add them before printing if necessary.
Movable or hidden elements.
Sometimes the moving parts cannot be printed because the supports inside the cross section cannot be removed.
Do you need support?
For some materials, angles greater than 45 degrees require supports to be positioned on the model. They do not damage the design and allow the printing of overhanging parts. This does not need to be taken into account, our technician will add them before printing if necessary.
This material uses DLP / SLA projection or laser stereolithography technology when printing.
Stereolithography is used to print your prototype with this material. The construction and positioning of a three-dimensional model takes place in specialized software, where it is cut into many thin layers, for their subsequent display using a laser or projector.
If necessary, auxiliary supports are created for working with protrusions and cavities, in view of the individual characteristics of each specific model.
The process takes place in a large reservoir of liquid material (polymer). The printer, using a laser or computer-controlled projector, hardens the first layer of resin. Further, by raising the platform (substrate), it hardens each subsequent layer, directly on top of the previous one. This cyclical action is repeated until the end of printing.
After the end of printing, the substrate completely lifts the finished model from the reservoir with the polymer to remove the excess polymer itself. Supports are manually removed after the model is removed from the substrate.
At a further stage, if necessary, the final hardening of the model takes place in an ultraviolet chamber.